m-PEG4-propargyl

Introduction

Intended Use

For the determination of Escherichia coli in drinking water and its source water by multiple tube fermentation method.

Principle and Interpretation

MUG permits the rapid detection of Escherichia coli when the medium is observed for fluorescence using a UV light. MUG is hydrolyzed by the enzyme β-glucuronidase which is produced by E. coli to yield a fluorescent end product 4- methylumbelliferone. Trypticase provides the essential nutrients. Lactose is the fermentable carbohydrate. Sodium chloride maintains the osmotic equilibrium. The medium has a strong buffering system to control the pH in the presence of fermentative action. The bile salts inhibit gram-positive bacteria especially the Bacillus species and faecal Streptococci.

Formulation

Ingredients	/liter
Trypticase or tryptose	20 g
Bile salts No. 3	1.5 g
Lactose	5 g
K2HPO4	4 g
KH2PO4	1.5 g
NaCl	5 g
4-methylumbelliferyl-β-D-glucuronide (MUG)	50mg
pH6.9±0.2 at 25°C

Preparation

Weigh 37g of dry powder of this product, add 1L of distilled water or deionized water, stir, heat and boil until

completely dissolved,  sterilize at 115℃ for 20min, cool to room temperature and set aside.

Quality Control

The following quality control strains were inoculated and cultured at 44.5℃±0.5℃ for 24h. The results are as follows:

Quality control strains	Growth
Escherichia coli ATCC25922	Blue-white fluorescence is produced under 366nm UV light
Salmonella typhimurium ATCC14028	No fluorescence under 366nm UV light
Enterococcus faecalis ATCC29212	Clear, no fluorescence

Storage and Shelf Life

2-30℃，Keep container tightly closed, avoid direct sunlight.

Use before expiry date on the label.

 Precautions

1. When weighing the dehydrated medium, please wear masks to avoid causing respiratory system discomfort

2. Keep container tightly closed after using to prevent clumping.

Waste Disposal

Microbiological contamination was disposed by autoclaving at 121°C for 30 minutes.

Intended Use For the determination of Escherichia coli in drinking water and its source water by multiple tube fermentation method. Principle and Interpretation MUG permits the rapid detec……

Description

genesig® kits are sold for research use only and are not licensed for diagnostic procedures.

Exceptional value for money
Rapid detection of 2019-nCoV
Positive copy number standard curve for quantification
Highly specific detection profile
High priming efficiency
Broad dynamic detection range (>6 logs)
Sensitive to < 100 copies of target Accurate controls to confirm findings

Description 

The DM1160 FluoroBand™ 50 bp Fluorescent DNA Ladder is a ready-to-use DNA ladder, which is pre-mixed with high sensitivity DNA binding fluorescent dye and loading dye for direct gel loading. The DNA Ladder DM1160 is composed of 17 individual DNA fragments: 1.5k, 1.2k, 1k, 900, 800, 700, 600, 500, 450, 400, 350, 300, 250, 200, 150, 100, and 50 bp derived from a mixture of PCR products and specifically digested plasmid DNA; these bands can be visualized when illuminated with 470 nm blue light or a UV light. This product contains two enhanced bands (500 bp and 200 bp) for easier reference. In addition, the low range Orange G tracking dye which mimics the migration of a 50 bp dsDNA during electrophoresis is also added for real time monitoring. Real time observation of the electrophoresis is also possible if compatible light source is fitted to the electrophoresis tank. 

Features

• Sharp bands
• Quick reference— enhanced bands 
• Ready-to-use— premixed with loading dye for direct loading
• Stable— room temperature storage over 6 months
• Directly observed by UV or blue light— premixed with high sensitive DNA fluorescent dye

Source 

Phenol extracted PCR products and dsDNA digested with specific restriction enzymes, equilibrated in 10 mM Tris-HCl (pH 8.0) and 10 mM EDTA.

Range 

50 ~ 1,500 bp 

Concentration 

54 µg/ 500 µl 

Recommended loading volume 

5 µl/ well

Storage

Protected from light 
Room temperature for 6 months
4°C for 12 months 
-20°C for 24 months 

The DM1160 FluoroBand™ 50 bp Fluorescent DNA Ladder is a ready-to-use DNA ladder, which is pre-mixed with high sensitivity DNA binding fluorescent dye and loading dye for direct gel loading. The DNA Ladder DM1160 is composed of 17 individual DNA fragments: 1.5k, 1.2k, 1k, 900, 800, 700, 600, 500, 450, 400, 350, 300, 250, 200, 150, 100, and 50 bp derived from a mixture of PCR products and specifically digested plasmid DNA; these bands can be visualized when illuminated with 470 nm blue light or a UV light. This product contains two enhanced bands (500 bp and 200 bp) for easier reference. In addition, the low range Orange G tracking dye which mimics the migration of a 50 bp dsDNA during electrophoresis is also added for real time monitoring. Real time observation of the electrophoresis is also possible if compatible light source is fitted to the electrophoresis tank.